Tensile Strength, Micro-hardness and Microstructure of Friction-Stir-Welding AA6061-T4 Joints
Tikrit Journal of Engineering Sciences,
2018, Volume 25, Issue 4, Pages 51-56
Abstract
Welding of aluminum alloys by traditional welding methods creates some defects such as hot cracks, porosity, and void that led to decreasing of mechanical properties. Friction Stir Welding (FSW) gives good mechanical properties of aluminum alloy welds. In this paper, FSW worked in 4 mm thick plate of 6061-T4 aluminum alloy, with two welding parameters are used (tool rotational speed and feed rate) was investigated, were analyzed the microstructure and mechanical properties by carried out microstructural, microhardness, and tensile strength tests. From results are found defect-free of welds at a wide range of parameters. Stir zone shows a fine-equiaxed grain and high hardness, not significantly change between heat affected zone and base metal in size grain. Tensile strength of welds was lower than base metal and fracture location was occurred at a low hardness region for the welds.لحام سبائك االلمنيوم بالطرق التقليدية يخلق بعض العيوب مثل الشقوق الحارة والمسامية والفراغات التي تعمل على خفض الخواص الميكانيكية للملحومات، لحام الخلط االحتكاكي يعطي خواص ميكانيكية جيدة لملحومات سبائك االلمنيوم. في هذا البحث دراسة للحام سبائك االلمنيوم (T4-AA6061) بسمك (4mm) بوساطة لحام الخلط االحتكاكي تحت متغيرات) السرعة الدورانية ومعدل التغذية(، وحللت الخواص الميكانيكية والبنية المجهرية من خالل اجراء فحوصات البنية المجهرية والصالدة المجهرية ومقاومة الشد. من خالل النتائج وجد ان البنية المجهرية لمنطقة الخلط ذات حجم حبيبي ناعم-ومتساوية المحاور وذات صالدة عالية وليس هناك اختالف مميز في الحجم الحبيبي بين منطقة المعدن األساس والمنطقة المتأثرة بالحرارة، مقاومة الشد للملحومات أدنى من مقاومة الشد للمعدن األساس وموقع الكسر للملحومات حدث في منطقةالصالدة المنخفضة.
- Article View: 221
- PDF Download: 145